The components of the set:

Acconic A200 LiFePO4 12V lithium bottom seat supply battery 200Ah

Lithium batteries offer several advantages over conventional lead or AGM batteries. This makes them particularly interesting for use in motorhomes:

• Longevity: LiFePO4 batteries last over 3000 cycles at 80% DOD and even over 5000 cycles at 50% DOD. This means you probably won't have to change the battery for decades, which is cheaper in the long term than lead or AGM, despite the slightly higher purchase costs
• Space-saving: Motorhomes are often dependent on limited space. With lithium batteries, you can save valuable storage space, as they are much more compact than lead-acid or AGM batteries.
• Lightness / low weight: If you need to stay under 3.5 tons, you can save a lot of weight with a lithium battery, as they are only about 30-40% of the weight of lead-acid or AGM while having twice the usable capacity. So with 15 kg of lithium, you can enjoy the usable capacity of 80 kg of lead-acid or AGM. This leaves more charging capacity for other loads.
• Absolutely safe, gas-free and heat-tolerant. The combination of lithium, iron and phosphate does not release any oxygen. The battery can therefore not burn or explode.
• Low self-discharge and an integrated battery management system (BMS) mean you don't have to worry about damaging your battery through deep discharge.
  

With 200Ah, the A200 delivers a total of 2560 Wh. This is enough battery capacity to charge an I Phone 240 times, charge a laptop 40 times or power 8 LED spotlights for 480 hours. You could operate a normal compressor refrigerator for 96 hours with this battery.
This makes it the ideal battery for larger campers. If you ever need 230V AC power, you can also easily connect a 2000W inverter here. Everything you need in a larger camper or motorhome (water pump, lights, charging cell phones and laptops, compressor refrigerator, kettle/coffee maker, blender, etc.) should be able to be supplied by this battery over several sun-free days (without any charging by solar). Only if you have really large consumers, such as a 230V induction hob, a water boiler or a fan heater, will this battery not be enough.

The A200U is also particularly space-saving and fits perfectly under the seat box of a Fiat Ducato driver or passenger seat, for example. Alternatively, we also have the A200 and the A200S in our range.

If 200Ah or 2650 Wh is not enough battery capacity for you, you can connect another A200 in parallel.

NOQON NSC2012 2000W/12V sine wave inverter with charger, NVS and UVS function

Many laptop chargers, but also other electrical appliances such as induction fields, hair dryers, microwaves, televisions and kettles are operated with 230V alternating current. An inverter converts the 12V direct current from your battery into 230V alternating current. Make sure that you adapt the selected size of your inverter to the consumption of your electrical appliances.

The NOQON NSC models also combine an inverter and mains charger in one. This is ideal if you plan to stay at a campsite for several days. In this case, the vehicle's engine will no longer supply power and if there is no sun or you are standing in the shade, the battery can quickly run out. Most campsites offer sockets for mains power and you can use these to charge your battery via the NOQON NSC inverter.

Also very practical: Never NSC models have an NVS function. NVS stands for "mains priority switching", which means that the power you draw from the inverter gives priority to your mains power source, thus protecting your battery and allowing it to charge in peace.

NOQON NBS60 solar charge booster with integrated 60A solar charge controller

The NOQON NBS models combine an MPPT solar charge controller and charge booster in one device.

When the vehicle is stationary, a 12V battery can be charged via the solar module with up to 30Ah or approx. 400 Wh charging power. When driving, the NBS60 even has a charging capacity of 60Ah or approx. 800Wh.
For optimum battery charging, the NOQON NBS automatically adjusts the charging characteristic to the required values via the voltage measurement cables. In doing so, it compensates for line losses and voltage fluctuations of the alternator that occur while driving.

• Switchable charging characteristics for optimum charging of lead-gel/dryfit, AGM/fleece or acid/wet batteries as well as LiFePO4 batteries
• Standard protection mechanisms: Overvoltage and undervoltage protection for the main battery, undervoltage protection for the starter battery, overload protection for B2B charging, overheating protection, reverse protection, PV overload protection, PV overvoltage protection
• and much more
• Thin cables (2.5mm2) to tap the "D+" or a "terminal 15" / "ignition on" signal of your vehicle are not included in the set.

VOLTIMA Genio 190-36 solar module 190 watt monocrystalline

Genio modules are particularly suitable for mounting on the roofs of motorhomes or campervans. The angle of incidence of the sun is often lateral in the camper and so the light can be ideally reflected from the roof onto the lower side of the panel. In this way, a good deal of extra power can be extracted from a small space.

Alternatively, you can also use two normal modules such as the GSM180-36, or, if you don't have enough space on the roof with mounting spoilers, simply glue two flex panels such as the GSM180F-40 with mounting tape (you only need 1390 x 1340 mm space for this)

The expected daily output (April to October) is on average approx. 800Wh/day per BSM200-36
Dimensions of the BSM200-36: 1100 x 900 x 30 mm. (For two next to each other you need at least 1800mm + mounting rails space on the roof)

VOLTIMA 7-piece long complete mounting set for solar installation (white)

Spoiler profiles are the first choice, especially for caravans and motorhomes, when it comes to clean and long-term mounting of solar modules. If the modules are mounted in the direction of travel, wind noise is no longer an issue (this also applies to alcove vehicles). The complete mounting set also includes a cable feed-through. When fitted correctly, they are absolutely leak-proof and extremely durable.

Sikaflex 554 (Sika 252i replacement) 300 ml construction adhesive (white)

Correctly applied bonding is superior to any screw connection in tough motorhome or boat applications. A strength of over 4 N/mm2 can be achieved on painted or GRP surfaces, a value that would never be achievable with a screw connection in the thin aluminum or GRP carrier layer - and without any holes in the roof. This adhesive set enables even a layman to create an absolutely firm connection between spoilers and the respective substrate.

Under "Accessories", we have listed many other useful products that you can use to optimize, supplement or adapt your solar system to your specific needs.

Before ordering:

Climb onto the roof of your camper / caravan / motorhome and carefully measure whether you have enough space on the roof. Remember that you need space for the solar panel AND the spoilers.

Also take into account any objects that may already be on the roof (skylights, fans, antennas, satellite dish, etc.).

Also plan exactly where your cable feed-through is to be placed, where your charge controller is to be installed in the vehicle and where the supply battery will be and how long the extension cable from the solar cells to the charge controller or from the charge controller to the supply battery needs to be. If the 5 meters of solar cable and 1 meter of charge controller cable provided in the set are not long enough, you will have to adjust the set manually.

Installation:

Use the installation instructions for the individual products and the connection diagram in the pictures.

AIS Batterien GmbH accepts no liability whatsoever for application errors, changes or damage to the vehicle caused by installation or necessary modifications, not even if the product has to be dismantled again due to a material defect; in such cases, replacement can only be provided for the product itself.